SWR wire sensor

introduction

The SWR weight sensor is designed for steel wire ropes from diameter 5 to 13, and it measures the amount of weight through the tension and deformation created in the structure of the wire ropes.

Due to the fact that it is installed on each of the coils separately, it has very high accuracy and quick and easy installation. It is suggested that this sensor be used for projects with high capacity and stop where it is not possible to install the sensor under the cabin and the coil. Also, the weight measurement capacity of each SWR sensor depends on the coil grade. These sensors are individually connected to the VK or RCU control device by a 2-meter cable, like most of Dinasel's sensors.

Since a separate sensor must be prepared for each wire, if it is possible to install the sensor under the cabin, it is much more economical than SWR. However, Delta recommends the use of TCA800 under-cabin load cells in order to benefit from a very accurate result. The main difference between the SWR sensor and the common LCK sensor is its accuracy. Due to the individual installation on each of the wires, the measurement accuracy is increased and the error is reduced.

   

For installation, you can use a normal wrench or a special Dinasel wrench (call) use

Features

• Made by Dinasel Spain 

• European Union standard

• Has 1 year warranty

• 5 years after-sales service

• 24-hour service and support

• Quick and easy installation

• Weight measurement and loading restrictions

• The capacity of the sensor is 0003 kg

• Very easy installation and adjustment (Persian catalog of adjustment)

• Suitable for 2:1 suspension systems

• Weight holder inlet during cabin movement

• Ability to connect to VK and RCU devices  

Electrical specifications 

• Can be connected to VK-3SV and RCU 205 control device

• Very low energy consumption of the RCU 205 control device (2 W energy consumption)

• The control device RCU 205 is very low cost and optimal

• The VK control device has 3 output relays and the RCU 205 control device has 3 output relays for the range of full capacity and overload. . .

• Serial communication capability on the VK-3SV device (optional)

• It has 3 indicator lights of the weight range on the VK-3SV device (optional)

• Cabin display output on VK-3SV device (optional)

• Analog output on the VK-3SV device (V, 4 to 20 mA, 10 to 0) (optional)

• Very easy wiring and adjustment (Persian catalog of adjustment)

• Input power source of RCU 205 controller device (24 V-DC)

• VK-3SV controller input power supply (115~230V-AC)

• Nominal frequency 50 to 60 Hz

• Contact relays V - 3 amps 250

• The input voltage of the holder is 24V ~ 230V - AC / DC

• Device protection class V0 IP-50, fireproof plastic