OMEGA 800 towing tension sensor

introduction

Sensor RTM Dinasel Company (Dinasel) is specially designed to control, adjust and monitor the tension of the wire rope and to equalize the tension between the ropes, and it only measures the amount of weight, it does not limit it. The installation and operation of this sensor is very quick and easy without the use of tools, and it can be installed on top of the cabin or on top of the weight frame. This sensor has two models RTM 1 and RTM 2  are produced, which are separated based on the wire rope score and weight measurement capacity, which model RTM 2 , can pull the tension from the score 5 until 20 Slow measuring mm and weight measuring capacity depending on the grade of the wire 200 until 1800 It is kilograms. in fact 4 number RTM For the score 5 Total up to capacity 800 kg (Cabin capacity and cabin weight) are measured by each of the sensors by a cable 2 meter USB to the control deviceOmega 800-R  connects The number of sensors installed to measure traction and weight depends on the number of trailers, capacity and dimensions of the cabin. Be careful with a sensor number RTM You cannot balance the tension of all the towbars. This sensor and control device is designed in such a way that for comparison and software calculations, a sensor must be installed on each of the towbars separately and all sensors must be connected to the controller device at the same time.

 

Features

• Made by Dinasel Spain 

• European Union standard

• has 1 Warranty year

• 5 Years of after-sales service

• Service and support 24 hourly

• Stretch measurement and weight measurement

• Maximum accuracy in tension measurement 

• Very quick and easy installation without using any tools

• This device is used to control, adjust and monitor the tension of wire ropes (WRT)

• Cabin weight measurementCWT) and weight frame (CTWT) 

• Two models of sensors for different capacities and sizes of 5 to 20 mm cable 

• Sensor RTM 1 For the score 5 until 13

• Sensor RTM 2 For the score 13 until 20

• Sensor RTM 2 The wire rope covers the grade from 5 to 20 mm

• Quick setup with analog connection USB 

• Indicator light on the body of the sensor that indicates the exact point of connection to the cable

• "Automatic calibration" without the need to perform a step (specific weight) for final adjustment

• Ability to connect to the device Omega 800-R Individually 8 cell

 

RTM-1: nominal load (kg) cable diameter of 5 to 13 mm
Ø13	Ø12	Ø11	Ø10	Ø9	Ø8	Ø6	Ø5	mm
800	650	550	450	400	350	250	200	Kg

 

RTM-2: nominal load (kg) cable diameter of 13 to 20 mm
Ø20	Ø19	Ø18	Ø17	Ø16	Ø15	Ø14	Ø13	mm
1800	1700	1600	1450	1250	1100	950	800	Kg

 

Electrical specifications 

• Can be connected to the OMEGA 800-R control device

• The controller is installed above the cabin 

• 5-digit display with capacity indicator for connecting up to 8 sensors on the display

• Fast setup without tools with analog USB connection (Persian catalog of setting)

• Simple adjustment, with a bar graph showing the amount of tension deviation of the wire ropes

• Input power supply of OMEGA 800-R controller (V-AC 022)

• Rated current mA 130  

• Nominal frequency 60 to 50 Hz

• Device protection class V0 IP-50, fireproof plastic• 8 USB inputs of sensors on the device