TCA800 undercabin sensor

introduction

The TCA-800 sensor is special for installation and operation under the cabin and to prevent the transmission of vibrations, it is installed under the bumper instead of the cabin and it measures the amount of weight through pressure. This sensor is produced in two single and group models, in which 4 weight measuring cells are used in the group model of this sensor. In fact, 4 pieces of TCA-800 kg in total measure up to 3200 kg capacity (cabin capacity and cabin weight), which is connected to the VK or RCU-205 control device by a 5-meter USB cable. The number of installed sensors depends on the capacity and dimensions of the cabin. Installing 4 active sensors in the four corners of the cabin and measuring the weight of the cabin is the reason for the superiority of this sensor over other types of sensors. Also, TCA does not suffer from errors due to rail friction and mechanical movements, the weight of cables and compensating chains, loading on each floor and other factors that prevent correct measurement, and it is recommended to be installed and used on new elevators.

 

Features 

• SaLine of Dinasel Spain 

• European Union standard

• Has 1 year warranty

• 5 years after-sales service

• 24-hour service and support

• Weight measurement and loading restrictions

• Maximum accuracy in weight measurement
• The sensor is installed under the cabin and the controller is installed above the cabin

• Produced in 2 different types: single models TCA-800 / I - group model TCA-800 / G

• The capacity of the single model sensor is 800 kg and the group model sensor is 3200 kg

• Guru Haye model (× 4 = 3,200,800 kg) in which four cells are active and it is produced to increase accuracy, ease of installation and wiring of electrical connections

• The ability to connect up to 8 cells individually

• Very easy installation and adjustment (Persian catalog of adjustment)

• Installed instead of shock absorbers in order to prevent transmission of mechanical vibrations

• Its installation depends on the type of suspension system design is not

• AndRody holding the weight during the movement of the cabin

• "Automatic calibration" without the need to perform a step (specific weight) for final adjustment

• It is recommended to be used for the installation and commissioning of new elevators

 

Electrical specificationsQa

• QaConnecting bell to VK control device and RCU 205

• Very low energy consumption of the RCU 205 control device (2 W energy consumption)

• The control device RCU 205 is very low cost and optimal

• The VK control device has 3 output relays and the RCU 205 control device has 2 output relays for the range of full capacity and overload. . . 

• Serial communication capability on VK device (optional)

• It has 3 indicator lights of the weight range on the VK device (optional)

• Cabin display output on vk device (optional)

• Analog output on vk device (V, 4 to 20 mA, 10 to 0) (optional)

• Very easy wiring and adjustment (Persian catalog of adjustment)

• Input power source of RCU 205 controller device (24 V-DC)

• VK controller input power supply (115~230V-AC)

• Nominal frequency 50 to 60 Hz

• Contact relays V - 3 amps 250

• The input voltage of the holder is 24V ~ 230V - AC / DC

• Device protection class V0 IP-50, fireproof plastic

• Specifications of different models of controller devices