BPSXR User manual

(EN)

BPSXR

User Manual

Dinacell Electrónica S.L.

1 Introduction

1.1 Description

BPSXR load cells are a weighing sensor located at the fi xed point of cables on traction elevators load. In dinacell we have developed diff erent models of BPSXR sensors to be able to adapt them to the diff erent types of installations

1.2 Dimensions in mm

Wiring diagram

+ Exc. (Red) + Signal (Green) - Exc. (Black)

- Signal (White) Shield (GND)

2 Installation step-by-step

2.1 Place and way of installation

These load cells must be installed at the fixed point of the elevator. Below you will fin an installation scheme sensors for the different types of suspensions.

Rope Washer (s) Rope Springs or terminal Silentblock Sensor BPSXR Plate Plate Sensor BPSXR Rope Springs or terminal Silentblock Rope Washer (s) 1:1 Suspension Multiple suspension

2.2 Minimum distance between sensor

FIGURE 1 Min. distance between load cells for installation Model

2.3 Connecting cells to the device

Lastly, you must connect the cells USB to the load weighing control. To do this, you must take into account the steps indicated in the load weighing control manual to know when to make the connection. If you connect multiple BPSXR sensors to a load weighing control with only one input, you must use an INTERFACE. 3 A (A) BPSXR 50 A

Dinacell Electronica S.L. The information contained by the document is subject to change without notice. The content indicated herein should be used as an overview of the product. It should not be construed as a guarantee of quality or durability. Dinacell Electronic shall not be liable for technical or editing errors or omissions contained in this document.

Document Ref.: D2283-01

Publication date: 23/05/2025

Dinacell Electrónica S.L. Pol. Ind. Santa Ana C/ El Torno No8 CP 28522 Rivas Vaciamadrid, Madrid, ESPAÑA Tel. (+34) 913 001 435 Fax. (+34) 913 001 645 dinacell@dinacell.com www.dinacell.com